FAG 6200

Single row deep groove ball bearing with two rubber seals & C3 clearance 17mm inside x 47mm outside x 14mm width

Product Description

Single row deep groove ball bearings are used in a wide variety of applications, they are simple in design, non-separable, suitable for high speeds and are robust in operation, and need little maintenance. Deep raceway grooves and the close conformity between the raceway grooves and the balls enable deep groove ball bearings to accommodate axial loads in both directions, in addition to radial loads.

Single row deep groove ball bearings are manufactured as open type (unsealed), sealed and shielded, the most popular sizes of deep groove ball bearings are also produced in sealed versions with shields or contact seals on one or both sides, the bearings with shields or seals on both sides are lubricated for life and are maintenance free. A sealed bearings seals has contact on the bearings inner and outer, a shielded bearings shield has contact on the outer only, and Shielded bearings are primarily intended for applications where the inner ring rotates. If the outer ring rotates, there is a risk that the grease will leak from the bearing at high speeds.

Bearing Data – General RSH or RS = Sheet steel reinforced contact seal of acrylonitrile-butadiene rubber (NBR) on one side of the bearing 2RSH or 2RS = RSH or RS contact seal on both sides of the bearing

RSL = Sheet steel reinforced low-friction contact seal of acrylonitrile-butadiene rubber (NBR) on one side of the bearing 2RSL = RSL low friction contact seal on both sides of the bearing

Z = Shield of pressed sheet steel on one side of the bearing 2Z or ZZ = Z-Shield on both sides of the bearing